What could be better than the sound of a well tuned engine running?--- Two engines running in SYNC!
The TwinSync Synchronizer allows twin engine airplanes to keep the engines running at the same RPM and produce that unique sound when engines are synchronized in flight. The TwinSync does NOT operate on the Master/Slave principal and has a very fast reaction time to engine speed changes--commanded or otherwise--NO lag in maintaing sync.
Engine RPM information is supplied by easily installed Hall Effect Sensors.
The TwinSync has a unique safety feature that brings the running engine immediately to idle in the event that one engine stops with no change in throttle stick.
This feature prevents loss of control when one engine stops while flying the model. The pilot can regain control of the idling engine by simply moving the throttle stick to idle. Control is then returned to the throttle stick and the pilot has full control.
The TwinSync has another safety feature to kill both engines if the loss of transmitter signal is detected on a FM radio system. This feature operates similar to how PCM transmitters and receivers operate. If a PCM radio is used with the TwinSync it will operate as normal and the TwinSync has no impact on PCM failsafe operation.
The TwinSync has several additional modes of operation adding capabilities beyond just keeping the engines synchronized. These modes are detailed in the TwinSync manual.
NEW Version 2.2: Glow Drivers mount remotely (at the engines) from the twinSync module. Less wiring than verison 1.X TwinSync w/glow. A simple 3 wire servo lead is all that is need to connect the glow drivers to the TwinSync. Wires are provided to connect your batteries to the Glow Driver. A glow plug clip and ground lug are also provided.
$49.95 pair.
TwinSync Glow Drivers $49.95 pair
NEW Version 2.0 Glow Drivers mount remotely (at the engines) from the twinSync module. Less wiring than verison 1.X TwinSync w/glow. A simple 3 wire servo lead is all that is need to connect the glow drivers to the TwinSync. Wires are provided to connect your batteries to the Glow Driver. A glow plug clip and ground lug are also provided.
TwinSync Display Unit & TwinSync Magnets
TwinSync Display Unit $39.95
Standard Magnets (round discs, faces are polarized, for installation on spinner backplates)- 1.50/pair
Diametric Magnets (cylindrical, sides are polarized, for installing into drive hubs form the front side, high rpm applications)- 2.50/pair
